E.F. Johnson Company VR-CM50 Guide d'installation télécharger pdf (Page 50)

EQUIPMENT CHECK-OUT AND ADJUSTMENTS

6-4

February 1996

Part No. 004-3039-274

SCREEN 1

______________________________________________________________________________________

TOUCH THE UPPER LEFT POINT USING ONLY ONE FINGER

FINGER SHOULD BE PERPENDICULAR TO SCREEN

HOLD FINGER IN PLACE UNTIL YOU ARE INSTRUCTED TO REMOVE IT

Press ANY key to ABORT calibration

______________________________________________________________________________________

SCREEN 2

______________________________________________________________________________________

AFTER PRESSING UPPER LEFT, TOUCH THE LOWER RIGHT POINT USING

ONLY ONE FINGER

FINGER SHOULD BE PERPENDICULAR TO SCREEN

HOLD FINGER IN PLACE UNTIL YOU ARE INSTRUCTED TO REMOVE IT

Press ANY key to ABORT calibration

______________________________________________________________________________________

When the calibration is complete, the message

SF CAL Written, Calibration updated on Installed

SFKERN Driver , will be displayed.

c:\> prompt will display:

4. Initialize the CRT Console:

Reboot the system by pressing the RESET button on

the computer.

The Main Screen will then be displayed.

NOTE: if the Main Screen does not appear, check

the AUTOEXE.BAT file and make sure the drivers

are installed. If they are not, call for technical help

if you do not know how to install them.

6.5 AFTER SYSTEM CHECK-OUT

At this point, the E.F. Johnson CRT Console system

installation and checkout has been completed. If you

have any questions or problems, contact Technical Sup-

port, 1-800-328-3911. Be sure to complete and mail the

warranty cards for other manufacturer’s equipment, such

as the CRT monitor, printer, modem, etc. These can be

found at the back of the VR-CM50 Console Service Man-

ual, Volume 2.

1 2 ... 45 46 47 48 49 50

Pas de commentaire

E.F. Johnson Company VR-CM50 Guide d'installation Page 50