E.F. Johnson Company 9800 Series Manuel de service télécharger pdf (Page 13)

OPERATION

2-6

Revised January 2001

Part No. 001-9800-501

which follows). This list may contain up to 16 chan-

nels of any type (conventional or SMARTNET/Smart-

Zone) assigned to any zone. Radio wide scanning is

turned on and off by the Radio Wide Scan option

switch as follows. If this switch is not programmed,

radio wide scanning is not available.

• To turn radio wide scanning on, press the Radio

Wide Scan option switch. The icon is then

displayed continuously and “RWS ON” is displayed

briefly on the lower line of the display.

• To turn radio wide scanning off, press the Radio

Wide Scan option switch again. The icon is then

no longer indicated and “RWS OFF” is displayed

briefly.

• If the zone or channel is changed while radio wide

scanning, scanning continues normally.

Scan Resume Delay

When a message is received or transmitted while

scanning, there is a programmable delay before scan-

ning resumes. The delay after receiving a call prevents

another message from being received before you can

make a response, and the delay after transmitting a call

ensures that you hear a response to your call instead of

another message occurring on some other channel.

Standard Mode Scan List

NOTE: The selected channel is always scanned.

With conventional operation, up to three scan lists

can be programmed. The list that is scanned is selected

by the Scan option switch as described on Section

2.4.11. Selecting another conventional channel does

not change the current scan list. The scan lists are user

programmable if the Scan Edit option switch is

programmed (see “Programming a Scan List” which

follows).

With SMARTNET/SmartZone operation, each

channel can be programmed so that one of up to three

different scan lists is automatically selected or scan-

ning is disabled. The scan lists are user programmable

if the Scan Edit option switch is programmed (see

“Programming a Scan List” which follows).

Radio Wide Mode Scan List

With radio wide scanning, there is only one

preprogrammed scan list available regardless of the

type of channel selected, and it is not user

programmable.

Determining Which Channels are in Scan List

With standard conventional scanning, the selected

channel is in the current scan list if the box icon

(around “

S”) is indicated in the upper left corner of the

display. Channels in SMARTNET/SmartZone stan-

dard scan lists are indicated only when editing a scan

list. Channels in the radio wide scan list are not

indicated.

Nuisance Channel Delete

With standard scanning, both conventional and

SMARTNET/SmartZone channels can be temporarily

deleted from the scan list. This feature is not available

with radio wide scanning. Proceed as follows:

NOTE: The selected channel and conventional priority

channels cannot be deleted from the scan list.

1. While receiving a message on the channel to be

deleted, press and hold the Scan option switch until

the alert tone sounds (about 1 second).

2. The channel is then deleted and scanning of the

remaining channels in the scan list resumes.

3. Deleted channels are added back into the scan list if

any of the following occur:

• Scanning is turned off and then on again using the

Scan switch.

• The selected channel is changed.

• Transceiver power is turned off and then on again.

Programming a Scan List

If the Scan Edit option switch is programmed,

conventional and SMARTNET/SmartZone standard

scan lists can be user programmed as follows:

1. Make sure that both standard and radio wide scan-

ning are off (neither the standard scan “

S” icon or

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 68 69

Commentaires sur ces manuels

Pas de commentaire

E.F. Johnson Company 9800 Series Manuel de service Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Les radios bidirectionnelles E.F. Johnson Company 9800 Series